🏍️ Xitomer Fender Eliminator for GSXR 600/GSXR 750 L11 2011-2021 - Tail Tidy, Black Review

. Perfect fit for my 2017 GSX-R600. Easy to install and great price. If you cut off the factory wires, save a piece of the factory wire protector and use it on the new wires sticking out below.

Excellent quality material, bumped the road when fitted to my 2020 GSXR750z, the floor spacer was not square like a bracket so the corners of the bracket had to be rounded and the fairing fit properly. Otherwise no complaints, the LED light was easy to use and very bright!

Great product. It just works. Fasten the cables behind the lantern, remove the 4 10mm screws, remove the fender. Attach the plate, attach the light, thread the wires through the center hole using the shrink wrap provided. Take 2 of your original screws and USE them with LOCTITE. Run the wires through the rear seat area, plug in, turn the key, check that the license plate light is on, that it's lit, shrink wrap, done!

Approx. This product is worthwhile if you have a basic understanding of how strength and mass work. In addition, there is an opportunity to splice wires and use heat shrink tubing (the ability to solder is a plus). It's worth noting that this plate mounts just below the taillights, right where your fender was mounted. I know some people like to mount the plate closer to the wheel. I reused my old fender bolts because they are too long and the white LED is definitely bright enough so no worries.

The boy did it to me for the bow. First, the product has no instructions. If you have no mechanical or electrical knowledge. Go to the next product selection. Second, the product says it fits my Gsxr 750. It doesn't! I had to make serious adjustments to the metal. The mounting screws had to be calibrated (expanded). I did it with a metal file. I then had to cut the corners of the bracket with a saw so it would sit flush. Then connect the wiring for the LED license plate light. I installed it…