🔧 Enhance Precision and Efficiency with Yonico 15221 Matched Tongue Groove Tools Review

picks and offers a very close fitting mortise. I can highly recommend Yonico bits. If using these stakes with a hand or bench router, be sure to either adjust the height of each stake with a caliper/micrometer to ensure the surfaces of your counterparts are flush. Also because these connections are very close. need some glue. If I use more than one pea glue (or black bean glue) per linear foot, I get a little off the seam. like a pea sized drop in a groove and a cotton swab to spread it over…

From February until now I've had the same complaints as everyone else. Failed to align properly, wood burned, too many cracks etc etc. Well I learned a lot making 25 shaker doors. The first 4 were sent in the trash because they had too many flaws and the 5th was 1/4 inch too small. Even when I was learning how to use the router, it annoyed me. The old router was the cheapest single speed router. I just bought a 14 amp Craftsman and it solved the alignment problem as it stays where you put it…

These are my first set of slotted and slotted bits. I like them but they are by far the scariest baits I have worked with them: they're big and therefore cause a lot of vibration! My router and table really aren't the best for them and I had to fix and screw everything up before I could safely use them. I felt that even then in connection with more play than I expected.This might have been an issue in my setup (when looking at the parts out of the box, the parts seemed to fit together nicely.)…