🖥️ Zalman S3 ATX Mid Tower PC Case: Smoky Acrylic Side Panel, Three 120mm Fans, Patterned Mesh Design, Black Review

For standard air conditioning, I believe it will work flawlessly. Additionally, you can put at least six coolers and RGB backlights for the price, which is fantastic. But I do not recommend it for dropsy.

Remove the front panel of the case and cut off the plastic wall or fence (I'm not sure what it's called exactly) on the inside (it will be visible in the photo). This is a minor life hack for individuals who have purchased or are about to purchase this case, but the blank front wall causes them to feel uneasy. As a result, you have the ability to increase the size of the air intake holes on the front panel by 1.5-2 times. It is preferable to fix the front panel coolers on the inside so as not…

Stylish, minimalist case that is lightweight and has a transparent side cover. Only $2100. There are a ton of fasteners in the kit. Possibilities for managing cables. HDD 2.5", 3.5", and SSD bays are present. Three 120mm fans can be installed under the front cover. A long screwdriver is required to attach the motherboard to the casing because it is so close to the "ceiling" of the case, and connecting the processor's additional power supply can also be a hassle. There is a compartment for the…

The general consensus is positive. Zalman z3 plus duck was previously available, and it is equipped with numerous fans. Only one fan is available, but it costs less than a thousand dollars. The casing is attractive in its understated simplicity. Wires can be laid without a hitch if you put in the time and effort. There is enough for about seven 120-millimeter fans. The MATX board, as well as the gammax 300 fury cooler, fit without issue, leaving at most three centimeters between the case and…

Similar to the AeroCool Cylon, almost identical casing with the exception of a different front panel, both just purchased. Hardware: RX584 and i5 6400 (gammax 200T). Protsu is typically very cold. But when playing games, the video card is virtually always operating at full speed. GigabyteAurus, tdp 185W (fresh from the store; not used; not a miner). without dumping, marriage, and other things! I added a third valve for blowing out from above, one under the video card, and two more for blowing…

A good affordable option for a compact casing that has the space to accommodate a fairly long video card. Some pros: I was searching for a case that will accommodate a Radeon R390X video card, which is 32 centimeters in length. In standard ATX cases, removing the hard drive basket was required before the component could be installed. In this particular instance, the ergonomics on the inside are different. Despite the fact that the case itself is of a very small size, both the ATX-format…

Some pros: Nice, good quality and reasonably priced. I wanted to take more, but what's the point of overpaying? Different cons: Ahead, of course, it would be better if they made more ventilation, otherwise there are small holes .

I took a great case to replace the GMC H200 Phoong, which was huge for its size for a miditower and took up a lot of space on the table. With a little tweaking and tuning, it's quite an excellent body.

Seriously, decades of case design that could be used and you'd think someone would make an inexpensive case that does everything it needs without sacrificing functionality. Zalman did. This case is a bit small, but I was able to fit a Hyper 212 Evo in it (although I only have 1mm of space, so YMMV). The case covers all the basics for a case in this price range. Rounded edges (so no sharp edges), good airflow, dust filter, decent cable management (well-placed attachment loops and cutouts), full…

5 cm distance between the back of the power supply unit, where the cables are connected, and the hard disk bay. Nobody uses hard drives these days and I don't even have SATA SSDs, just an NVMe SSD connected to the motherboard. I will drill out 6 rivets and remove the tray. They could have made it removable by attaching it with just two screws like Corsair does with its Carbide series, but they didn't. This makes it very difficult to use a power supply with more than 400W in this case. The…

Advantages:1. It provides enough space for cable routing both between the back panel and the outer cover.2. It has a glass panel that hides the power supply. This glass panel also increases the space for cable management.3. In a dusty environment, I like the dust filters on the front, top, and bottom of the case. Cons: 1. I couldn't get all 3 front fans to work. I can get 2 in any combination but not all 3 at the same time. The problem is that the power cords are too short. I only have one…

Firstly, although the description says glass side panels are now supplied; You are not. It's still acrylic. But that would be good in itself. The side panel screws are overtightened at the factory, causing the acrylic to deform. The PSU bracket is curved in such a way that installing the PSU becomes a chore. I had to put it on to bend the shelf down when screwing it in, otherwise the holes wouldn't line up. There is no gap between the top of the mobo and the top of the case; However, the top…

This is a good case and although it is quite small it offers enough space. The case is fairly thin metal which makes it feel cheap, but does it really matter if it just sits somewhere? In fact, it might even be good, less metal = less weight. And the plastic pane is also light as a feather. The details on the inside will weigh it down nicely. The case has multiple USB ports on the top and 3 fans which is a nice touch. The fan on the back uses this tiny 3 pin cable that connects to the…

Let me start by saying that Zalman is a good company that has been around for a while and their customer service is excellent! Overall I am very happy with the performance of this case and the construction (see photo) came out and the price paid. This case is more suited to a micro build than a full size ATX board due to its small size. If you're buying a power supply at the same time, I also recommend looking for one that has flat cables for easier cable routing. I think this feature is more…

I bought this product because I thought there would be a decent flow of air through the side vents on the front. I was wrong. There's a plastic wall that blocks your view of the vents, so you can't see the front fans. The gap between this wall and the case, through which the air has to get to the fans, is very narrow. I used Microsoft's best technical charting program to sketch what I'm talking about. The red arrows indicate the limitation. Now, if you just stick with the two included front…