ZFE Quality Spacer Guide Pack for Air Plasma Cutter Cutting Wsd-60P Sg-55 Ag-60 - Set of 5Pcs Review

Too expensive for what they are. 5 small pieces of wire bent up. Order just the minimum quantity and use them as self bending stencils for only pennies each. Updated rating. These models are not only too expensive, but also too small for a standard plasma torch (pt31).

Works pretty well for what they are designed for. They are by no means perfect, but will keep your advice away from metal. For the price they are ok. The only problem with my order was that it took MUCH longer than stated to receive it. But I wasn't in a hurry, so it's okay. The instructions are what they are and I am happy with my purchase. Will I buy again? yes if i need more

Would like more and better documentation, e.g. B. A user manual with all information on setup, use, diagnostics and repair if necessary. I have never owned a plasma cutter, always used an acetylene torch for cutting, but I was able to set it up and set it up to work properly. Passed the learning curve but the machine cut 3/16, 1/4 and 1/2 inch sheet steel as intended. If it lasts then the price is great. Not five starts because the documentation was very bad.

I bought these because they were supposed to fit the Cut 50 torch as you carefully examined them and found there was no way they could fit in there to hold if there is no groove around the cone of the nozzle. So if you look at the white atomizers on sale, NONE have a groove so they are useless. And they are not shiny like in the photo, maybe they are galvanized. And they don't come in the packaging shown, so I think they're fake.