🔧 Mcvcoyh Gas Can Replacement Spout Kit - Super Long Flexible Pour Nozzle with Strainer and Gasket, Vent Caps, Stopper Caps, Collar Caps - Ideal for Water Jugs and Old Can - Pack of 2 Review

Rigid and not flexible enough. The bottom of the spout is too small in diameter. The gasket fits the neck, but even with the included threaded neck mount, it still doesn't seal the Midwest cans. It flows. I had to use an old thread lock and non-standard gasket, otherwise it will let through both steam and when pouring liquefied gas.

Failed to load media. They replace the spouts on my 25 year old gas cylinders with actual vents, before the EPA when gas cylinders were good. These spouts are ok but nowhere near as good as the ones that came with my tanks which have held up so far. They don't have the best seals and they roll so they leak around the seal when pouring. They worked a little better on another brand, I had an older can but still had a slight leak. They might work better on much newer cans, but if you have good old

I'm a bit disappointed with these replacement parts. As you can see from my photos I was only able to mount one of the 4 gas canisters I have. My smaller gas bottle fits the black cap but when I try to push the spout through the black cap the seal comes loose. It's too tight and doesn't allow the use of a pad with a black cap. Without this seal, gas leakage will occur. The quality of the parts is really good. It's a really nice set and maybe if you have all new petrol cans all these will suit…