🛢️ Moeller Marine Products: Fuel Tank Sending Units for 4 to 28 Inch Tanks - Enhanced SEO Review

Replaced defective sensor with an older Sea Ray (97) bowrider. Apart from the fact that part of the floor and the rear seat support had to be removed (not Möller's fault, of course), the biggest problem was installing the new unit. The kit comes with both a gasket and mounting bolts, and I blindly used new bolts (they're beautiful). After tightening them, I admired my work and accidentally pressed on the gas tank, which caused a slight over-pressurization in the tank, causing gas to leak around

If I could give no stars I would. I usually buy locally so I know what I'm getting but my nautical shop said not until Monday next week. I was looking for a replacement sensor for my right hand fuel tank and found it with the delivery at the right time. An exact replacement for what I had. I received the PIC "Universal Fuel Level Sensor". If I wanted to tinker with the universal transmitter, I would have ordered it. Unfortunately, I had very little time to get the boat back into service. I…

I ordered one of these probes and probe sets in June. Then I broke my leg and the project of installing a native transmitter and gauge into my old Searay project dragged on. When I went about installing them 5 weeks later, I found that what was supplied was basically the same transmitter as pictured, set up for 4_24" deep tanks, but the transmitter configuration was very different from that unit shown. The package included instructions for the sender how to set the depth but there are no…