Header banner
Revain logoHome Page
sydien pneumatic cylinder connector mal25x150 logo

Sydien Pneumatic Cylinder Connector MAL25X150 Review

3

·

Average

Revainrating 3.5 out of 5  
Rating 
3.3
🔩 Pneumatic Equipment, 🚰 Hydraulics, Pneumatics & Plumbing

View on AmazonView on ЯM

Media

(4)
img 1 attached to Sydien Pneumatic Cylinder Connector MAL25X150
img 2 attached to Sydien Pneumatic Cylinder Connector MAL25X150
img 3 attached to Sydien Pneumatic Cylinder Connector MAL25X150
img 4 attached to Sydien Pneumatic Cylinder Connector MAL25X150

Description of Sydien Pneumatic Cylinder Connector MAL25X150

✅Piston rod thread: M10X1.25mm; Port size: G1/8";Max.Press: 1MPa; Single Rod double action. For more parameters, please see the product detailed pages. ✅Thickened cylinder body, high quality sealing rod, imported grease. The body of the cylinder is made of high-quality aluminum alloy with high strength, which is non-deformed, resistant to impact and abrasion. ✅Two screw hole connections to get the air in and out, and a rod connected to the plunger that goes in and out. High quality dust ring to protect bearing. Oil-bearing bearing life is longer, better piston rod, tightness, suitable for long-term use. ✅Cylinder is a mechanical devices which utilize the power of compressed gas to produce a force in a reciprocating linear motion. A unique sealing structure is adopted, the connection between two ends and the cylinder adopts a riveting process. Before shipping the goods to you, we will check to ensure that the cylinder seal is not leaking. ✅Package Content: 1Pcs x MAL25 x 150 Mini Pneumatic Cylinder & 1Pcs x Y Connector & 4Pcs x Quick Fitting.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

Fits my application

Fits my application. My lowlow goes up and down with no problem. I've pushed 250psi so far, but it's still holding up. had to change a little bit to install it properly

Pros
  • Great price
Cons
  • Big and bulky

Revainrating 3 out of 5

high friction

piston seal has high friction. Once it starts moving it's free, but it takes a little effort to break the o-ring and get it moving. It is difficult to achieve smooth action. The pressure builds up and nothing happens, then it goes on quickly. There will be no problem if higher pressure is applied to the piston (50+ psi is great), but if you're trying to run at low pressure for low forces, friction comes into play. If you want smooth performance at 5-10 psi, this isn't for you. The quality is…

Pros
  • impressive
Cons
  • boring packaging

Revainrating 2 out of 5

Without a job, Rod didn't move at all.

Right out of the box I couldn't move the pole. GENERAL. Cylinder disassembled, the rod rotates normally. Finally, it turned out that even with moderate tightening of the top cap, the front part of the cylinder body pressed against the stem, compressing it so much that the stem did not move. He took out the front o-ring and used a round file to remove some material from the edge. Reassembled and now I can move it by hand with the top cap tightened. Tolerances gnaw at it to the point of failure…

Pros
  • Easy to Use
Cons
  • Quick Start Guide