🌀 Powerful SUNON EE80252B1-0000-A99 DC Brushless Fan - 80mm x 80mm x 25mm, 24 VDC, 75mA Review

0.1A fan replaced with this one. It blows more air with less power. Unfortunately, the noise I wanted to eliminate is still there. It doesn't have vibration isolation in the mount, so I'll have to get something from the hardware store if I want to reduce fan noise.

I bought this to use as a motherboard fan for my Ender 3 v2 3D printer. I previously bought 2 other fans and both stopped working within a few days, so I started to suspect I had a problem with my motherboard. However, this one has been working for a few weeks without any problems. It's a little noisier than other fans I've bought, but much more reliable. The main downside is the lack of a connector, which requires you to either crimp the connector or cut and solder the connector from my…

As a cupcake fan, this fan is a bit loud but otherwise good. This is the right fan to fix Viking's noisy fridge fan problem. The swap is easy for those who can use a screwdriver and twist the two wires together. Fridge finish lid over noisy fan has plugs on both ends. Use a regular table knife to carefully remove them. The four Phillips screws then remove the cover. Four more hex screws loosen the old fan. You need to cut the wires and connect the new fan to the old connector. This fan isn't…

I bought this fan to replace one in my 12v power supply. The old fan was squeaking and would soon fail. Installation was very easy. The fan is a bit louder than I would like. It's not annoying, but I can hear it.