Literally a few feet from 5 stars, although it was just long enough for my truck, I had to set the handle back quite a bit to keep it from being too short. I adapted the end of the wheel to my Dana 60 HD Full Float by cutting the factory cables and using the springs and clips from them. I would also consider adding some thin (very thin) washers to the attachment on the skid plates if you are using a heavy duty axle. My factory wiring holes are big enough that the locar pieces barely go through without pulling them through, thin washers on each side of the baseplate hold this in place. I was surprised at how small the faucet is, at least from the outside it seems logical that it should have been much larger.