Review on 🟨 Yellow Flex 3D Printing Filament - REPRAPPER 1 inch by Glenn Cho

Some notes: I kept this in the filament dryer while I printed with it. When I'm not printing, I immediately transfer it to an airtight dry box. I slice my prints with the PrusaSlicer starting with the flex profile and setting the temperature to 225/50. I also have a 0.4mm hardened nozzle (not needed for TPU, but I print abrasives occasionally. I've had quite a bit of success with this filament. I've used it to print Prusa face shield headbands for the pandemic). (see image). The layer adhesion is excellent. Durability is also pretty good as I have to pull hard on the straps for them to break. Additional slicer settings are required.