Review on 🔩 Primefit PCKIT26 Air Piping System: 26-Piece Push To Connect Kit with 1/2-Inch OD / 3/8" ID x 100-Feet TPEE Tubing by Darnell Nahabet

I was just trying to install my Primefit PCKIT26 and found that the parts they sent me do not fit. Specifically, the kit comes with 3 "bleed blocks" that they don't provide specs for (i.e. is it 3/8" or 1/4" NPT?). Due to the fact that all push-in fittings are supplied with 3/8" NPT M threads, it is clear that the top and bottom of the block are 3/8" NPT F threads. However, it can only be assumed that the face of the block is 1/4" NPT F since they have 1/4" NPT x 45 degree connections. It is assumed that one unit will be installed on the compressor and 2 such units should be installed on site. The package includes 2 45 degree fittings to be used in the field to allow push to connect fittings to be installed for easy air access. Here's the crazy part. The supplied 2 x 45 degree fittings are 1/4" NPT threads, but the outlet blocks are 3/8" NPT F threads. They offer 2 x 1/4" male to male connections, but unfortunately they cannot be used on units that only have 3/8" F NPT connections. These. You cannot use the connections provided on the block provided !In fact the male to male connectors they provide can only be used on 45 degree connectors that can't be mounted on anything else they provide.It's just crazy.It should be "KIT" be. Who makes a set of parts that don't fit together? Now I have to go and buy specific parts to actually use my kit. If you look at other kits from PrimeFit you can find photos of the blocks placed that match the ones attached to the Show blocks mounted 45 degree connectors. Can't because they don't fit. I will come back and revise my review depending on what the seller decides to do to fix the problem. It's just bad desi gn, poor quality control or misleading or sloppy advertising for Revain.