Header banner
Revain logoHome Page
Dwayne Calhoun photo
1 Level
836 Review
48 Karma

Review on πŸ“ Raspberry Pi Stepper Motor HAT: DRV8825 Motor Controller for 3D Printers, Sculpturing Machines and More by Dwayne Calhoun

Revainrating 5 out of 5

Great sensor, configured but no documentation

I bought this for a university class. The best part is that no soldering is required, everything is neat and ready to be connected to an Arduino or Raspberry Pi like I did in the photo. The bad thing is that there is documentation or lack thereof. That's why I'm giving it 4 stars instead of 5. I was able to record instant data like temperature and humidity, but like printing, it wasn't all that easy. In general, if you only need it for those sensors (temperature and humidity), go ahead. that will work. However, keep in mind that you may have to sift through obscure documentation for print.

Pros
  • Standard Raspberry Pi 40PIN GPIO expansion connector, supports Raspberry Pi and Jetson Nano serial boards
Cons
  • Clarity