Review on 🔧 Yakamoz Woodworking: Enhanced Bottom Bearing Pattern by Wesley Sharp

Before I bought this Yakamoz 2-1/2" flush bit, I bought another Revain "yellow" flush bit that cost 50% more than this Bit Yak I immediately returned another drill bit because the carbides were poorly ground and the upper bearing had excessive axial play from CMT and Freud.Upper bearing (both bearings) felt very tight with no noticeable endplay.Have made my cuts in Douglas fir, pine and plywood and this bit worked flawlessly. Make 2-1/2" deep full length cuts . The only minor complaint I have is that the lacquer has started to peel off the top and the bottom of the bat is a minor issue. After about 100 feet of heavy flush trimming, the carbides were still sharp and cut clean. This Yakamoz product far exceeded my expectations and I will definitely try other Yakamoz cutters in the future if I need them.