Review on 🖨️ High-Accuracy ISANMATE Filament 3D Printers by Timothy Barnes

Tried to print the same part 3 times, Creality CR10S Pro V2. It was super fibrous every time. The first time I reset because I didn't like my support system and it was in all caps so I wasn't wasting material, this reset was on me, no big deal, still very sticky. The second time it's fibrous, with temperature changes throughout the day, the higher was actually the least fibrous (who knew!) At night it was still fibrous enough to clog the nozzle and eventually backfired and destroyed it Bowden hose clamp and broke. through the extruder's tailpipe and sheared off the teeth in the nut, rendering it unusable and no longer gripping the Bowden tube. the good blue material also had to be cut, but it was too short to continue using it. I rewound the PLA and went again after changing the nut and nozzle because I couldn't get it to unclog it was so bad even trying at 260 degrees. it was crazy So let's go again, everything went great today, it was about 26 hours, printed properly, was really afraid of bits of fiber, and then it happened again. It's nonsense, I don't dare to put the last half of the spool in my printer, I'd rather throw PLA away and just don't risk my printer anymore. Use it and replace parts, you've been warned.