Review on 🚽 Optimized RecPro Miracle Probes: Waste Water Holding Tank Sensors with 4 Probes by Justin Bishop

I bought 3 packs or 12 sensors. When I saw the picture it turned out that there was a slot in the tip of the metal rod so a small screwdriver could hold the probe while the nut was tightened; smart yes NOT CORRECT!. There is a notch to show which side is down but no slot. As expected, the entire probe rotates as the nut is tightened. I couldn't hold the threaded shaft tight enough with my fingers to keep the entire probe from rotating. So I used a small pair of pliers to hold the stem, damaging the threads. PLEASE ADJUST THE END OF THE ROLL SO THAT THE SCREWDRIVER CAN RESIST TWISTING! Old sensors have the same problem; So pliers damage the threads when removing the wire; Note that the old nut must be put back in place and tightened to prevent the old plug from leaking. The tiny screwdriver slot saves you hours of tedious work. Let's see if they hold up.