Review on 🖤 3DXMAX ASA 1KG Black 1.75mm Filament by Ikki Martini

There were some complaints in my initial review, but I liked the results after setup. clogs instantly so I've had better results with fans on, but after fixing the issue it works closer to default. My old review was about slower print speeds and adding fan cooling to the print quality part, true, but that's not how this stuff works when used properly. Please use my information below instead. After fixing my build issues, print temperatures of 250°C and 255°C on the first layer with 0% fan speed inside a closed space on the Prusa Mini are perfect. Ignore the minor layer shift errors in my photos, I need to rebuild my printer and I have a bearing issue that causes a constant slight layer shift due to bearing issues, but on a stable printer this should come out almost perfect just by setting the right temperature and storage of indoor printing to avoid warping. My print settings, if not listed, are used by default in PrusaSlicer for ASA: Printer: Prusa Mini (clone) Fan speed: 50% Case: YES (required) Adhesion add-ons: Magigoo helps prevent warping, but you can be good results without. I only use it for complex prints. The default speed in PrusaSlicer is roughly the same as the Prusa ASA thread settings.