Review on 📐 Enhanced Dimensional Accuracy of Filament 3D Printing by Genene Locson

I bought a few reels to try because it was cheap and I needed black. It has a matte black finish that almost looks like it has additives in it. Like it has to be carbon fiber or something. So far I've successfully printed two things. Neither seemed to go very well, almost like stacking rolls of clay if the clay spattered into clumps and didn't hold up well. And those were prints that did well. In all, I looked at two rolls to figure out what was wrong with my printers, more than two. Note, those weren't my printers. I had to interrupt 10 prints in just under an hour. Clogs interfering with my jets (.4 and .6 and a few others). Adhesion is terrible. feelings are terrible. The view is terrible. It's just bad. If I could get something over 10mm to print and glue I would love it more. In addition, he is weak and brittle. I will try my luck with another pair of reels as not worth returning. It's worth my time to take it down and turn people off of it. Cheap for a reason.