Review on Cordless drill driver BOSCH GSR 120-LI 601.9F7.001 by Jnis Zels ᠌

1) The engine burned out after a year and a half of infrequent domestic use - I suppose it was due to sparking (the last months it smelled like Amazon), inevitable during a sudden stop - but how can a stop be smooth if the screw is usually twisted to a ratchet? . or someone does it not spin? 2) Explicit loosening of the ratchet - any large screw can no longer be completely screwed even at 20 3) Removing the battery - requires considerable effort, wiggle, etc. - for a relatively frequent change in professional use, this, I think, is not quite acceptable, and even annoying in everyday life 4) The flashlight beam crosses the axis of the cartridge at a distance of approximately 50 mm from the end of the cartridge - i. E. the slot of the screw can be illuminated either by shifting the bit from the axis, or by moving the bit away from the screw - at a distance of at least 25 mm from the bit. In general, when using conventional non-extended bits - the slot of the screw is in the shadow of the chuck.