Then the first layers of the roll were fine. The layers are hidden under the layers, causing the printer to pull and break the filament. The coil winding is terrible. The chimp could have packed it better. How to wind a coil where layers are underneath other layers? To get any print at all, you should try to pull the foot out and then roll it back while printing so it doesn't mess up your print. Adhesion to the printing platform is also poor. I run almost all of my filament at the same hot end and layer temperature, and this one of my many spools of filament won't stick unless I heat the bed much more than normal. Some areas stick, but the corners stretch and warp too easily. You also pay more for this as it is not a 1kg roll. I would avoid it if I were you. There are many more options with better price and quality.
HATCHBOX Silver Performance PLA 3D Printer Filament - Dimensional Accuracy+/- 0.03 Mm For Superior Printing Results
30 Review
HATCHBOX 1.75Mm Silver Silk PLA 3D Printer Filament - Dimensional Accuracy +/- 0.03Mm, 1Kg Spool
32 Review
YOYI 3D Printer Filament - PETG 1.75Mm 2.2Lbs(1Kg) Spool, High Accuracy +/- 0.03 Mm, 100% New Raw Material!
32 Review
High-Quality Melca Black PLA 3D Printer Filament, 1Kg Spool, 1.75Mm Diameter With Precise Tolerance
30 Review
🖨️ ANYCUBIC Assembled Innovation Off Line Printing: Streamline Your Printing Process with Cutting-Edge Technology
5 Review
UV Curing Standard Photopolymer Printer by IFUN
5 Review
🔵 IFUN 3D Rapid Resin - Low Odor Photopolymer Resin for 405nm LCD 3D Printer - Fast Curing, Standard Rigid Formula - Sky Blue, 500g
5 Review
Flashforge Adventurer 3D Printer with Detachable Precision Leveling System
6 Review