Review on Hooshing Female Bulkhead Fitting with Enhanced Connector by Jerardo Phi
Poor Design - Requires additional parts to work
A washer needs to be added to this bulkhead to work properly. Two standoffs are placed between a flanged nut (good) and the receptacle side of a flangeless connector (bad) to support the rubber gasket. A washer really needs to be added to properly seal/tighten this gasket. As such it's semi-functional, but anyone using it to seal a liquid vessel is advised to add a washer or look elsewhere.
- Tube fittings
- Some bugs
New products
Comments (0)
Top products in π§ Fittings
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
