I don't know who designed the 90 degree oil filter mount on jeeps, but it's very bad. In any case, to fix an oil leak, you need to buy a T60 torque head. Get hit and knock out that little bit of torque. Unplug the outlet. Reach to the 90 degree angle of the oil filter and find where to insert the torque bar. Stick it in (you may have to dig up some sand/dirt) to install. torque bit. You need to craft something like a Rube Goldberg crowbar, as Jeep in its infinite wisdom used Red Locktite for the bolt that you need to remove. I used 18" x 3/4" galvanized pipe (one end flattened to fit a wrench). It broke him. Use the wrench to remove the screw. Push down to remove elbow and filter. Clean the cylinder block surface. Remove the filter from the elbow to replace the internal o-rings. Put the large o-ring where it belongs (see knee slot), add some oil to lubricate, fasten the screw without red Loctite (try blue or none at all). Tighten the screw carefully. Made. end of the leak.
πͺ FEL-PRO VS 50569 R Valve Cover Gasket Set: Superior Performance and Durability
9 Review
5W-40FS A3/B4
24 Review
RKX Vacuum Reseal Rebuild Gasket Replacement Parts
9 Review
π§ FEL-PRO VS 50561 R Valve Cover Gasket Set: Superior Quality and Durability for Optimal Engine Performance
9 Review
AIR LIFT 25804 Air Shock Controller Kit: Precision Control for Optimal Suspension Performance
3 Review
ποΈ ARANA Camper Tonneau Supports C1608054 - Ultimate Companion for Safe and Stable Camping Experience
9 Review
π Enhance Your Ride with Rough Country Front End Leveling!
9 Review
Air Lift 60828HD 1000 Air Springs: Enhanced Suspension Upgrade for 2019-2021 Dodge Ram 1500
4 Review