Any HB-26 brand is a good substitute for the Polaris RZR. Just snap off the useless lugs at each end, being careful to center the bearing so it runs within the in/out range of the driveshaft. Normally, therefore, a rubber boot is blown out. Polaris doesn't know how to set them up properly at the factory. Just thought I'd step in and share this information with my fellow RZR hobbyists who are trying to save a few bucks. Happy trails!
๐ง CRS NT515050 New Wheel Hub Bearing Assembly for Ford/Lincoln/Mercury 2002-2005 - Front Left/Right, 2WD/ 4WD, w/ABS
10 Review
๐ง Black Ten Factory MG21103 Dana Axle
9 Review
Toyo Proxes T1-R 245/45 R18 96Y summer
65 Review
๐ง Timken SP580310 Pre-Greased and Pre-Sealed Bearing Assembly
9 Review