Header banner
Revain logoHome Page
πŸŽ‰ effortless load support: unveiling the coast to coast hb26 hanger bearing logo

πŸŽ‰ Effortless Load Support: Unveiling the Coast To Coast HB26 Hanger Bearing Review

3

Β·

Average

Revainrating 3.5 out of 5Β Β 
RatingΒ 
3.3
🦾 Bearings & Seals, 🏎️ Performance Car Parts & Accessories

View on AmazonView on Π―M

Media

(4)
img 1 attached to πŸŽ‰ Effortless Load Support: Unveiling the Coast To Coast HB26 Hanger Bearing
img 2 attached to πŸŽ‰ Effortless Load Support: Unveiling the Coast To Coast HB26 Hanger Bearing
img 3 attached to πŸŽ‰ Effortless Load Support: Unveiling the Coast To Coast HB26 Hanger Bearing
img 4 attached to πŸŽ‰ Effortless Load Support: Unveiling the Coast To Coast HB26 Hanger Bearing

Description of πŸŽ‰ Effortless Load Support: Unveiling the Coast To Coast HB26 Hanger Bearing

Frames constructed from cold rolled steel for additional strength. Lubricated for life ball bearing with metal reinforced seals. Water resistant grease between the bearing and bearing caps providing an additional barrier from moisture and contaminants. Available for domestic and import automotive and light truck applications. Components are sample inspected at each process to insure all dimensional and visual specifications are met with 100% final inspection prior to packaging assuring the highest level of quality.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Don't waste time

It's cheap junk. Don't waste your time. I replaced my original bearing after 14 years when the shoe broke. After 1 week the boot was torn again.

Pros
  • Waterproof grease between bearings and bearing caps to provide an extra barrier against moisture and contamination
Cons
  • It's ok

Revainrating 4 out of 5

Good camp for the money. Fits 2016 Polaris RZR 900S.

Good bearing, fits 2016 Polaris RZR 900S. You'll have to bend and snap off the little protrusions, but it's not that hard. If you are reinstalling the drive shaft yourself, you can attach a strap to the bushing (see photo) to lift it when you change the shaft to the rear spline. This will prevent it from snagging on the frame if you want to slide it back.

Pros
  • Available for domestic and imported cars and light trucks.
Cons
  • Some disadvantages.

Revainrating 5 out of 5

Ideal for RZR gimbal OEM alternatives.

Any HB-26 brand is a good substitute for the Polaris RZR. Just snap off the useless lugs at each end, being careful to center the bearing so it runs within the in/out range of the driveshaft. Normally, therefore, a rubber boot is blown out. Polaris doesn't know how to set them up properly at the factory. Just thought I'd step in and share this information with my fellow RZR hobbyists who are trying to save a few bucks. Happy trails!

Pros
  • Cold-rolled steel frame for added strength
Cons
  • Some Cons