Review on Welding machine Elitech AIS 200SYN (MMA, MIG/MAG,TIG) 220V 50-200A(MIG), 10-160A(MMA), 10-200(TIG) by Mateusz Kot ᠌

In general, I recommend. I'm canceling the race for the lack of a key, for nozzles. Pros below: Until I tried it in work, I'm waiting for the onset of heat. I'll work and write more. Obvious pluses are the ability to work both in automated mode and manual settings. Iron mechanism, wire broaching. Wires, if not copper, then at least not made of iron. Clear control logic. Wide wire range (0.6-1) I liked the reverse polarity solution, no stupid tail Thick cable, I wonder if the same wire is there? Nice design, neat build. An anti-dust protective screen, a controversial decision, but nevertheless, it is better to have it than not. The sleeve is still difficult to assess, but it seems to inspire confidence. The main thing came whole, although there were damages on the box. The instruction is in 2022, not perfect, but at least understandable. Cons: Mass tips painted iron. Instead of a stupid mask, it would be better to add a coil of wire. Of course I would like it to be cheaper. There is no key for the nozzle, roller for 0.9 and with a notch for flux wire.