Review on 📱 7-inch Raspberry Pi Touch Screen Case Holder - Kuman by David Hodgson

Kuman 7 inch Raspberry Pi touch screen case holder perfectly fits the 7 inch Raspberry PI screen from all angles but to be honest it failed it is perfect after installing all sides of the 7 inch screen, it cannot cover the front of the 7 inch Raspberry Pi screen where the gold colored electrical wires are clearly visible, as well as some of the gold colored screen bezels on all sides of the front . Therefore, it cannot give a neat and clean appearance to the attached screen. In my case I didn't put the Kuman case on a 7" screen connected to a Raspberry PI system, I used the screen as a stats monitor in the PC case, showing my CPU, GPU, RAM and etc. shows stats until I play. I would appreciate and love the Kuman case more if it covered all the exposed parts of the screen when viewed straight on as it would give my screen a much cleaner and tidier look. Unfortunately this was not intended. I was also very surprised that the holes in the acrylic panel are too small, even for the screws that came with the kit. I literally lost a screw trying to install it in the case and the screw's threads were sheared off as the screw just didn't fit the tiny smaller hole. I had to use a drill to make all the screws bigger to fit the screw properly. If you don't have a drill with the right bit size, you will be very annoyed. A good product for the price with the disadvantages mentioned above.