Review on Tools T Handle 4 Inch Capacity 12001 by Randy Bin

Bought this tool to cut 2 holes for 6-48 bolts. I read the reviews and a lot of people seemed to say it was cheap junk, but I really didn't want to spend a ton of money on a tool that I would use once and probably never use again. The packaging says it requires a 0-1/4" drill bit. However, I wasn't able to tighten the chuck enough to hold the bit in place. Not even close, actually. It turned on tightened to a certain point and then just let go. twist without tightening. my guess is broken threads on the chuck. But even so, it was useless for the project I was working on. I ended up just putting the faucet in the cordless drill plugged in. will break if over tightened (the whole point of using a hand wrench is to avoid this) Was able to tap some good threads without breaking the tap but absolutely 0 thanks to this tool I have tried to return it , and Revane says it's non-refundable so I think I wasted $9.Either buy another wrench or just use a power tool.But if If you go this route, use lots of lube and GO SLOWLY so you don't damage your faucet!