Review on π© YDS Stainless Steel Worm Drive Hose Clamp with Adjustable Diameter Bandwidth by Andy Jolley
Range not quite accurate
YDS Stainless Steel Hose Clamps 1/2" to 1" are high quality hose clamps. They can take a good amount of torque without slipping. However, the 1/2" size can be a little oversized. I used it on a 5/8" hose and the yoke was as small as possible and I had to twist it hard to keep it from leaking. If it a 1/2" hose would be I don't think it would still be round and might not work. For 1/2" I would recommend a 1/4 - 5/8" clamp.
- Industrial & Scientific
- Skimpy Instructions
New products
Comments (0)
Top products in π§ Fittings
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Another interesting products
Durable and Versatile: Happy Tree Polycarbonate Industrial Equipment
3 Review
Ultimate Performance: SpringSpray Aluminum Equipment Heavy Duty Industrial for Optimum Productivity
3 Review
π§ Thermoplastic Aluminum Fitting Equipment by SAFBY
3 Review
SAFBY Nozzle Thermoplastic Equipment Spray
3 Review