So I figured the issue for other reviewers might have been an accident, but it appears to be an issue with the product in general. I have a Raspberry Pi 4 with an official power supply and a small fan connected to pin 1 of the GPIO (3.3V) and that's it. After only about 20 minutes of transferring files via WinSCP, I went to the command line and got a low voltage warning. It seems that this product just can't sustain the required performance while running the Pi under full load with a small fan. I'm giving it 2 stars as it still works for its main purpose, but if you have something connected to the GPIO or running something CPU intensive your mileage may vary. Ultimately I'm disappointed and my advice is to find a solution other than this one.
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
MacBook Retina 13-inch (A1425, A1502) and 🔩 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review