Review on 📀 Black Monoprice 108101 DVD Bracket for Enhanced SEO by Shedrick Roach

I *love* Monoprice; They are of course usually a source of inexpensive high quality cables. Their 3D printer was an unexpected success. But this product is the worst I have ever bought from them. It's so bad I feel like I need an apology from them. The product is pretty simple. There's a nice tempered glass shelf held in place by two plastic brackets and rubber feet that should be bolted to some really heavy steel studs. They provide hex screws to assemble everything and that's where everything falls apart. holes. I don't know what they did - did they powder coat after drilling and tapping? Pierced with a worn out faucet? -- but getting her to take the bolt is next to impossible. If you have a faucet handy you might be able to solve this problem, but good luck everyone else. The best thing to do is try to crack the screws. If you do this with the included hex wrench, you'll have to compete to see which round comes first, the wrench or the screw. Worst case scenario, you receive the product half assembled and then have to figure out how to put it back in the box to get it back. or the washers needed to attach the bars to your TV's VESA points. If you're already using a VESA mount, you might be able to use the same screws, but I wouldn't trust that. Even if everything works, it looks like it will end up looking like duct tape and wire work. I don't know what to suggest in place of this product, but don't be fooled by Monoprice. Surname. This article is a complete failure.