Review on Gizmo Dorks Acetal Filament Printers by Ray Cole

Was not vacuum sealed Update: After drying I was able to print some of these materials. It can warp a lot and has trouble sticking to most bed surfaces. What I really like is taking two-ply shop towels, separating the halves and using a glue stick to glue the smoother side to the build plate. This will give you a nice rough surface that will weave into your raft. My prints always stuck to this surface, but my desk couldn't get warm enough so it ended up picking up a work towel right off the glass bed. I think with hotter bed temps this will print better. The body helps too. I should also add that I get better prints by setting my nozzle temp to 185-190 instead of the recommended 210-220.