Gizmo Dorks Acetal Filament Printers Review

Was not vacuum sealed Update: After drying I was able to print some of these materials. It can warp a lot and has trouble sticking to most bed surfaces. What I really like is taking two-ply shop towels, separating the halves and using a glue stick to glue the smoother side to the build plate. This will give you a nice rough surface that will weave into your raft. My prints always stuck to this surface, but my desk couldn't get warm enough so it ended up picking up a work towel right off the…

As mentioned before, this is a very difficult filament to print. It is very difficult to stick to the bed and is very prone to deformation. I couldn't get it to stick to a PEI bed, a standard Prusa PEI bed, or an "aftermarket" bed. CS Hyde PEI film, even at the highest temperatures my beds could endure (100C and 120C). However, I figured the acetal should stick to the acetal, so I ordered an acetal sheet and attached it to my bed. Printing at a table temperature of 100°C I was able to get the…