Review on Calorbot 260X200X0 15mm Anycubic Photon Printers: Unleash Your Imaginations! by Mohmed Burt

I'm not sure if this is my fault or not. I'm new to SLA printing. But I've watched countless videos and so far have had very good success rates in learning the hobby. With my experience in FDM printing, it wasn't difficult. But apart from that they seem good, they fit my anycubic mono x. But I seem to be going through it very quickly, enough to cause concern. My first FEP that came with the printer was about 20 prints. I was lucky enough to get 5-10 of these. I install according to the instructions and handle the foil very carefully. But I don't seem to get very long to use them. They seem to have a lot of holes as there is always resin on my LCD screen.