Calorbot 260X200X0 15mm Anycubic Photon Printers: Unleash Your Imaginations! Review

So both my breaks were from the same box so it could be a bad batch. I swapped out the FEP plates before and after the first break, I just thought "this happens." The second time it was a crack that put enough resin in my printer and now it's ruined. I don't normally write reviews but I am very upset to lose my printer to this product.

I punched a hole in my FEP to get rid of the bad printing and ordered these as a replacement. They were larger than the frame but that's not a problem and there aren't any screw holes but I believe that's just because they fit multiple printer sizes. Making special screw holes was very easy. I simply placed the FEP board on top of the frame and used a needle to poke small holes that I enlarged with an Allen key before inserting the screws. After attaching it to the frame, it remains only to cut

I'm not sure if this is my fault or not. I'm new to SLA printing. But I've watched countless videos and so far have had very good success rates in learning the hobby. With my experience in FDM printing, it wasn't difficult. But apart from that they seem good, they fit my anycubic mono x. But I seem to be going through it very quickly, enough to cause concern. My first FEP that came with the printer was about 20 prints. I was lucky enough to get 5-10 of these. I install according to the…