Review on 🚛 Vixen Horns Truck/Car/Semi Train Horn Kit - Complete Onboard System with 200psi Air Compressor, 3 Gallon Tank, and 4 Trumpets - Extremely Loud dB. Suitable for Pickup Trucks, Jeeps, RVs, SUVs - 12v VXO8330B/4114B by Jacob Andreti

horns. The picture was misleading. Air hose missing. There is no hose for a remote filter. There are no lock washers to attach the horn. Lightweight horn mount. Not needed. The short braided hose from the compressor limits the mounting options. No female connectors for horn wires. Such short horn wires could not even be grounded to the mounting screw. According to the diagram, there is no 10 A fuse in the fuse holder. According to the diagram, there is no 30A fuse holder. Ring connector on the pressure switch cable and flat connector on the pressure switch. The PREMUM thread tape included in the kit did not fit. Leaks from all fittings except one. I had to use regular tape. After re-taping all the leaky fittings, I had a leak in the weld on the tank. I need a replacement tank that won't leak at the weld. VERY disappointed with this whole set. RB Barnby 443-801-8101 Got a replacement kit and changed my air tanks. Again I had a leak. This was at the safety valve. Contrary to common sense, I tightened the relief even more and twisted the relief. After removing the relief, I installed another relief that came with the new kit and it also leaked on the carving. I just took it off and put in the safety valve I had on hand and it didn't leak. These relief valves are not manufactured correctly. The nut should be in the main valve body, not on top where there isn't enough metal to handle turning when tightened. This whole kit was a huge disappointment and if it hadn't been removed and repackaged I would have sent the entire kit back. After hooking up the system to work, I was disappointed with the sound. They're not very loud, and the valve in the horn itself is leaking, causing the compressor to kick on and charge about every two hours. This whole system is such a disappointment and a waste of money. A New Tank I had to replace a tank with a leaking weld on the plug. I had trouble getting one of the fittings to stop licking it. I finally tried the cork and cured the problem. I don't think the Chinese know what an NPT thread is. They want everything to be metric.