(1) Good tool. (2) The tool is a bit tricky or clumsy until you make some holes. (3) Once you feel that this tool is very good and highly recommended. (4) The tool comes with a wide range of hole punches. (5) I just tried to punch a hole in a copper coin (about 14ha, 0.078 inch thick) and it was a real struggle. (6) Some have asked about .0625 inch stainless steel military dog tags, of which I would look for a steel or stainless steel stamp ranging from 14 ga (0.078 inch) to 16 ga (0.0625 inch) thick . Also, the punch should have a cutting edge (a slight angle at the end to cut into the metal before drilling a hole), not a flat edge. The flat edge on the end of the punch is suitable for aluminum and sheet metal up to 16 ga.
Secure And Efficient: HTS 164P5 6" Non-Slotted Locking Pennington Forceps For Precise Handling
23 Review
π© Revolutionary Revolving Screwdriver with Grinding Saddle: The Ultimate DIY Tool
9 Review
π‘ TH0037 Electrical Hydraulic Knockout with Enhanced Warranty
9 Review
Capri Tools CP21050 21050 Puncher
9 Review
High-Performance Bosch BS80 6W Bandsaw - 80 Inch 4 Inch Blades
11 Review
πͺ Durable DEWALT DW3986C Portable Blade 3 Pack for Efficient Cutting
10 Review
πͺ Bi-Metal Cutting Blades: Imachinist S933414 - Enhancing Precision and Performance
10 Review
Enhanced Cutting Efficiency with Olson FB23370DB 0 025 2 Inch Blade
10 Review