Review on Filament Printing Material Metallic CC3D by Robert Buenconsejo

In summary. Beautifully printed. But getting it stuck to the print bed is a nightmare. Gluing layers together is another nightmare too. My recommendation. Tap slow and hot. For example 30 mm/s and 230°C. And use masking tape to tape the bed and heat the bed to 60°C if possible. That's the only way I could get it to stick, and even then it's not a guarantee. Lots of edges around the base won't hurt either. Finally, print at least 4 wall thicknesses when using a 0.4mm head. Otherwise, the outer surface may bend inward slightly or not adhere properly. It was very frustrating to print but the prints you receive are amazing.