Review on 10.5 fl oz Cartridge of 3M Auto Glass Urethane Windshield Adhesive, Product Code 08693 by Rodney Harris

I wanted to leave a review mainly to let people know that the tube I ordered came with a nozzle. Also, I use a regular caulk gun to apply it. I think this works out to about 14 linear feet depending on the width of the bead. One tube was enough to stuff half the bead around the windshield of this Cadillac Seville. I did NOT use primer, I just used a caulking scraper to scrape off most of the old glue. It had a latch on the back that looked like a tube of grease (which bothered me at first) but you just pull it off and there's a plastic disk inside the tube that you can squeeze with a caulking gun. I would recommend COMPLETELY removing the protective film from the end of the tube and if you are using it for a windscreen you will need to cut the nozzle roughly in the middle where it is almost at its widest point. This makes a good sized bead, and while it's a bit harder to push out than seal, it's doable. It's also probably a good idea to let the tube warm up in the sun before applying, especially on a cold day. We didn't want to spend a lot of money on this project because it's just a battered race car. I am completely satisfied with this product. This saved me a lot of money! * This is an honest review of a product that I paid for myself.