Review on 🚗 Pentagon Under Vehicle Car Dollies with Heavy Duty Roller Wheel Casters - Set of 4, Black by Jim Bethea

6:30 am and I hear a diesel engine near the house. Don't worry, today is garbage collection day. Then I hear the hydraulics and the overhead gate working. In the driveway the alarm sounds and the German Shepherd goes berserk On the left side of the porch is an 80# crate of car skateboards Installation was quick and easy and required a 19mm jack I left that MB E320 falling on each roller No protesting sounds of metal or rollers can be heard Machine 3500r Moving a car on roller skates over concrete still required a stable footing, levers and permanently attached body panels When the rollers initially aren't aligned in the direction you want to go, it may take a little cardio to deflect the skate 90º before redirecting it to its destination due to the dog hair and the small amount of sand on the concrete floor, I had to do a few "hits" to get the boost multiple times. NOTE: My front wheel width is 8.75 inches / 225mm. The rear wheel is 10.5 inches / 265mm wide. . The front end just cleared the roller bolt/nut. The wider rear tire is in contact, so I put a piece of wood between the tire and the skate. So, although the product description says the plate size is 12" x 16", don't let that fool you. Note that if you intend to use the skates on an SUV or truck, the side of the tire may touch the protruding brackets. A hole is punched in the center along one end (for attachment). I tied a climbing harness to it so it's easier to grab if I need to hang up my skates and get them off the ground. I bought Pentagon skates, although they were slightly more expensive than Harbor Freight wagons based on reviews that advertised stronger metal skates. Thickness. I'll review the warp in about a week and give an update if anything changes. Update: The rolls on Pentagon Sake are 3 inches in diameter. The following month I upgraded those skates and replaced them with a combo wheel/jack design that featured 4 inch casters.