Header banner
Revain logoHome Page
William Bell photo
1 Level
1309 Review
75 Karma

Review on Whiteside Spoilboard Surfacing Router Bit by William Bell

Revainrating 5 out of 5

The cutting edges are finely ground to create a very flat and even surface.

I use this to finish a chipped CNC router plate and the cut edges were very sharp and I was surprised that all the cut edges were perpendicular to the vertical. axes and all in the same plane by 0.0005 inches! The result was a finish that performed as well as bits that cost a lot more. On passes with 40% overlap I could see NO tool marks on the very fine grain MDF surface.

Pros
  • Slim design
Cons
  • Long delivery time