Review on 🔴 Red Nylon 6 3D Printer Filament by KODAK by John Murphy

I was able to print this right after drying in the Esun dryer. I used an open printer first, an I3 Mega with a full metal e3d v6 hotend, 250 glue, no fan and 80 on a glass platform. Also with 18 edges. Gave a good print but I had more deformation than I expected. Another thing to consider, I had some kinks where I had the supports, so I'll probably have to adjust my settings for the roof and base there. I waited a few days to receive the case I ordered and installed everything there. .I tried the same settings, I was able to print with no problems. The surface is good, the adhesion is satisfactory. So I increased the bed to 90 and reduced the speed from 50mm to 40. Nicely printed, no warping. But I made a mistake. What I have noticed is that it has completely cooled down inside the case and the prints are very good now. This material prints better and is easier to use than most PETG filament I've used in my humble opinion. Now my only complaint. Reel wrapping is terrible. It came off the spool and I had a hard time keeping the line on the spool. The coil is also not very even. Although I will say I had no trouble tying it. Overall, I have no problem recommending this thread. It works fine for the parts I want to use it for, just do it step by step. I also believe that the body is a must for this.