🔴 Red Nylon 6 3D Printer Filament by KODAK Review

According to the ad, I decided to buy this yarn because of "premium yarn with lowest moisture content" and a well known brand. This was my first time using Kodak filament. The filament lay well out of the box, but the print was very brittle. I thought maybe it wasn't as dry as advertised so I dried it for 6 hours. The prints were still very brittle and not very smooth. I tried different tempi because I thought they would work best with settings other than those listed. I've even followed…

Good print quality when dry. There was still a vacuum in the metalized pouch and the filament was still damp when I unwrapped it. Look at the photos. The cloudy part was printed with filament straight from the bag. I heard the filament when printing. I dried the filament on a roll in my oven on a warm setting for two hours and printed the part that isn't blurry in the photos. After drying it is MUCH BETTER. I paid $17 for a 750g reel which is not bad at all for nylon. I bought the pack on a…

I was able to print this right after drying in the Esun dryer. I used an open printer first, an I3 Mega with a full metal e3d v6 hotend, 250 glue, no fan and 80 on a glass platform. Also with 18 edges. Gave a good print but I had more deformation than I expected. Another thing to consider, I had some kinks where I had the supports, so I'll probably have to adjust my settings for the roof and base there. I waited a few days to receive the case I ordered and installed everything there. .I tried…