Programming the board was a bit difficult. To turn it on, 5V was applied to the 5V line rather than the Vin line. (3.3v to 3.3v line didn't work either). It appears that the reset pin is not broken, so programming via the serial port will require a manual reset of the board. Using the CameraWebServer example thumbnail, the camera should have been defined as CAMERA_MODEL_AI_THINKER and not the default CAMERA_MODEL_WROVER_KIT. The camera has a very noticeable rolling shutter, but I think it's a software issue.
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
π Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
π₯οΈ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review