Review on 🔧 Enhance Your 3D Printing Experience with AMOLEN Filament & Supplies by Robert Xayamonty

There are a few other filaments from this brand that work fine but for some reason this blue/silver one just didn't stick. It acted like it needed more heat, even at 220/75C it didn't stick at all. I tried a hairspray I never use, the bottom layer started to stick and then peeled off like it was too cold. It also seems to be thinner than the multicolored glow I switched to after that, which has held up well without any modifications and normal PLA temp. Either I have a bad batch, or it takes a lot more heat to bond than intended.