Review on 💨 Efficient Cooling Solution: MasterBox Micro Tower Interior Radiator by Sean Maile

- The side vent can install 2x120mm fans through the grille holes, although you'll have a hard time installing a heatsink unless They have a low profile component. The side panels are interchangeable. While this is less attractive in terms of airflow and there is no gap or fans needing to run on the back of the motherboard, it's better than pushing the vents against the wall if you want to position the case sideways against a wall with drive bays . face to the left. It can also be useful for those who want to start modding with a clean slate. Case legs are made of 100% plastic. The front panel sits 12mm below the bottom of the case and the included feet are 18mm thick. As a replacement, I recommend rubber feet with a thickness of at least 15 mm. I would not recommend cutting off the front panel as the gap is needed for air intake from the front. If you wish, you can run this case without a front panel as long as you have enough space between what's inside your drive. Bays and your power supply. This reduces the overall depth by an impressive 33.5mm if you don't mind the looks. See attached photo of the side panels reversed and removed from the front. The maximum depth of the heatsink and fan is around 80mm, although of course this will shorten the length of your GPU unless you're only running a 120mm cooler in the top front grille slot. Budget building, but there is potential.