Review on 💽 Corsair Black CSSD-BRKT2 Dual SSD Mounting Bracket - 3.5 Inch by Jesse Azuse

Installation of the lower SSD micro screw kits is almost impossible due to the side slot design. These micro-screws are non-magnetic and there are no holes at the front ends of the front slots and no holes at the rear bottom slots that would allow an installer to drive and then insert the micro-screws into the new threads of the SSD pair Journey. through the open slots and tighten the fasteners. I had to use 1/2" newspaper strips with a tiny hole to hold the micro screw in place while carefully lowering it next to the mounting hole to grab a few threads, then ripped out the paper strip and repeated the same on the remaining three mounts. on the lower SSD brackets. This device seems to have non-magnetic micro-screws that are more likely to get lost during installation as it is currently designed. With slots cut out for a hole at the front of the slot on the front of the carriage and at the back of the carriage on the rear pair of slots, the installer can thread the micro screws into the SSD and then insert into the mounting slots.