Review on 🚗 Enhanced CDEFG Mud Flaps Splash Guards for RAV-4 2019 2020 2021, Mudflap Fender Flares Designed for Front and Back, 4-Piece Set (Black) by Maalik Harris

Great product. Perfect fit for both my Rav4 XLE 2019 and my Rav4 XLE Hybrid 2020. Those who checked this to say it left a gap simply didn't install them properly. For the rear you need to remove the top latch (tip: use a butter knife) and the bottom 10mm screw (under the car). Install the fender by first installing the 10mm factory screw, then reinstalling the top clip. Once these two steps are completed, press the fender down until the gap between the fender and the factory trim is closed and hold it in place by installing the two screws provided with the short screwdriver provided (this will help if an assistant holds the fender). up when attaching screws). When transferring, the process is similar. Remove the top and bottom (under the car) clips. Attach the fender and loosely install the two screws that came with the kit (here I cheated and used a #2 Phillips percussion gun and just turned the front wheels left or right to give clearance). Don't tighten them yet. Reinstall the top and bottom clips, then while holding the fender up to close the gap between the fender and the factory trim, tighten the two screws you loosened earlier. Enjoy your new fenders! The whole installation took about 15 minutes. The only fault I find with them is that they don't supply the right number of screws (requires 8, only 6 are included) so you have to visit a hardware store and buy 2 more. Make sure any screws you purchase are either plated or stainless steel.