Review on 🔌 HYCLAT 2-4 Gauge Battery Quick Connect/Disconnect Wire Harness Plug: Efficient Connector for Recovery Winch, Trailer, Motors - Pack of 2, Gray by Sick Yeldell

I use these to connect directly to the battery to run a 1000w inverter. Really well done. The process of attaching it to the wire is a bit painful. They appear to be aluminum so after a few tries I couldn't use normal soldering methods. The crimp was insane, they are incredibly tough. My typical single point crimp tool that I often use on 4 gauge didn't even leave a mark. I ended up using the fender on a large set of breaker rods with a 3" cheat rod and it still took a lot of effort! And as a result, the crimp is ugly, but it's also not going anywhere. The plug is really good thanks to the bolt attachment points and I'm sure the cap will stay in place!