If you purchased this resistor pack, your fan may still run at the high setting (4) as this setting bypasses the resistor pack. However, you may also need a new fan as the resistor bank usually fails due to excessive heat causing the solder joint to fail. The heating is caused by the fan consuming too much power. If this is the case, the new resistance pack will fail for the same reason, perhaps sooner rather than later. When I removed my fan it needed more torque to spin than a new replacement. The positioning of the fan and resistor pack is a little awkward, but it only requires a few tools and I believe many people will be able to get the job done.
Zento Deals 8 Pieces of 6 Ohm 50W Load Resistors – Eliminate Flickering LED Turn Signal Lights, License Plate Lights, and DRL
9 Review
💡 57294 Powermaster Alternator
9 Review
Electrical AFD0097 3F1U 10300 AA 3F1Z 10346 AB VP3F1U 10300 AA
10 Review
⚡️ Powermaster 9600 Str Master Infi-Clock: Chevy Universal Straight Mtg 153/168T Flyw 14:1 Black Wrinkle - Supercharged Performance Ignition System
10 Review