Received this end mill from USPS on Sunday as promised. My goal was to cut a slot .375 wide and .375 deep in a piece of cold rolled 1 inch round bar. This was for a blade guide bracket on an antique Delta band saw. Rong Fu) for the mechanical part of this project. This end mill cut great, although the difficulty of changing three belts to get the right cutting speed meant I ended up using too low a RPM. very good, did the job in eight consecutive passes. Too much overcut at low speed resulted in a lot of chatter so I had to take my time. After that, the knife still felt as sharp as before. I am very happy with this operation.
Enhanced Cutting Efficiency with Olson FB23370DB 0 025 2 Inch Blade
10 Review
🔪 Bi-Metal Cutting Blades: Imachinist S933414 - Enhancing Precision and Performance
10 Review
POWERTEC 62-Inch 8-Inch Blade - Model 13132X
12 Review
High-Performance Bosch BS80 6W Bandsaw - 80 Inch 4 Inch Blades
11 Review