Review on 📷 KODAK Black 1.75mm Printing Filament by Logan Collier

So I finally got around to using this filament and I was not impressed. I got some mediocre prints, but other than that they were problems. Here are the pros and cons. Benefits1. Nice lockable bag. Disadvantages (when using the improved Ender3) 1. Brittle - The filament breaks easily when bent or may break when fed through the Extruder2. In general, most prints did not adhere. I use a Creality PEI sheet on a heated bed and have never had any issues with prints sticking. I thought maybe the bed wasn't level and checked the level after each dip. Final error. I just remove that stuff and replace it with some SainSmart, restart the print and voila, no problem.3. Not only did I have issues with it sticking to the record, it also liked to stick together and caused problems with my hot end. I use Direct Drive and Micro Swiss, ran with TPU and have never experienced such a messy result. It's on 5 when I get the chance but I don't hold my breath